三分时时彩Nowadays, all walks of life are developing very fast, especially in the construction industry, many flats have been built high-rise buildings. Even in the countryside, there are small foreign buildings built. It can be seen that our living standards have improved a lot. When it comes to the construction industry, the GRC line will be used. It can be used to decorate the house and make it look beautiful. There are three ways to install the GRC line of the GRC line, one is to fix the shrinkage screw, the other is to fix the direct welding screw. Or the GRC members fixed to the wall of the steel frame are welded to the steel frame. These three methods can be used to decorate the lines on the construction site. The third method is described in detail below.
三分时时彩1. According to the construction drawings, the locating line (midline or edge line) is ejected at the position where the GRC component is to be installed.
2. When gluing GRC components, the mesh cloth should be retracted. If there are special circumstances, the mesh cloth can be directly pasted without retracted. The thin layer full bonding method is used for bonding, and the EPS component is extruded forcefully to make the mortar overflow from the periphery, and the bonding joint width is not more than 3 mm. The bond seam should follow the bond, the grey seam should be full, and the surface of EPS components should be kept clean.
3。 For the larger GRC components, the installation is required, and the support should be set up for temporary fixing。
三分时时彩4. When installing, if splicing is needed, the assembly dimension and angle should be measured in advance, and the pre-assembly should be carried out in the flat place, the gap is not more than 3mm. Bonded mortar is used as splicing and bonding material. The consistency of mortar can be sold more. The method of thin layer full bonding is adopted. When splicing, it is required to press and hammer slightly and evenly in order to make the grey seam meet the requirements.
5。 Gray knife is used to flatten the joints after splicing, so that the GRC components can be integrated。 After drying, if there is excess bonded mortar left at the joints of GRC components, it can be polished with mortar paper。 After drying, the special anti-cracking glue for splicing parts of GRC components is treated。 The treatment method is shown in the instructions for the use of the special anti-cracking adhesive。
三分时时彩6. After construction, the GRC components should pay attention to the protection of finished products, and no pedaling or heavy impact should be allowed. In case of damage, the whole EPS component should be removed and reassembled.
三分时时彩Installation steps are explained in detail, I believe you have understood that its application is very extensive, can be seen in many places. And able friends, after purchasing a new house, can also use GRC lines to decorate and install, will make the whole house appear particularly atmospheric, upgrade. We also look happy and energetic. So, GRC lines are very useful. I hope you can learn more about it. Maybe we will use it one day later. It's also good to be prepared in advance. There is a lot of knowledge to know. The most basic is its installation, many people may not be able to operate, it does not matter, Xiaobian to explain the installation steps of GRC lines for you.